![]() The splash screen image dimensions should not exceed 390 * 260 (width * height).Īfter making these changes, you can view the changes with the new splash screen and the logo in the MegaRAID Storage Manager software when you log in to the MegaRAID Storage Manager software.Ĭopyright © 2011 by LSI Corporation.Screw M10圆5 4 LSI LOGIC L2-25391-02C LSI MEGARAID SAS - 6GB/S LP RAID. The logo image dimensions should not exceed 160 * 85 (width * height). if your birthday is April 7, 1969, you will add 7 + 4 + 1 + 9 + 6 + 9 5mm by.Would be: logo_test_1.png or LogoTest1.png or TEST_SPLASH_FILE.jpg. File names for both entries should not have any spaces.Start the application.įollowing are some important points that you need to keep in mind: Enter the value for the splash screen file against the key CHANNELSPLASHSCREEN. Enter the value for the logo file against the key CHANNELLOGO. Imported the provided MIB file into PRTG and I am still unable to see controller messages in PRTG. Open the file msm.properties in the folder.Ģ. I installed MegaRAID Storage Manager and the SNMP Agent. To enter the file names, follow these steps:ġ. To customize the logo and the splash screen, enter the logo and the splash screen file name against these entries. No default values are assigned for these keys, therefore the MegaRAID Storage Manager software uses the default LSI logo and the splash screen. The msm.properties file has no values for the following keys: You can customize your logo and the splash screen by editing the msm.properties file present in the folder. MegaRAID Storage Manager Software Customization LSI MegaRAID Storage Manager (MSM) Windows(R)/ Linux operating systems. To check the status of the MegaRAID Storage Manager services, run the command svcs -a | grep -i msm. The ASUS PIKE 1078 allows you to create RAID 0, RAID 1, RAID 10, RAID 5, RAID 50. To start the monitor service, run svcadm enable MSMMonitor command. When the service is in maintenance state, run the svcadm clear MSMFramework command and svcadm clear MSMMonitor command. To start the Framework service, run svcadm enable MSMFramework. To stop the Monitor service, run svcadm disable -t MSMMonitor.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |